Concha Pan Dulce Bath & Body Works Soap Holder
Print Profile(2)
Description
Similar to the capybara soap holder, the design does not require supports. You might need a dab of glue if your filament is too well calibrated and the top plate is a little loose. Both face down and embossed design plates are available (for the top piece). The other side CAN be coloured too (labelled on the plates) but this will require more colour changes and will use the face down design.
Designed for 259ml soap bottles, but 236ml should work too, let me know if it doesn't!
Print 1 top plate and 1 main body of your choice then press fit the two pieces together. If the pieces are too tight, try the TOP plate that has HIGHER CLEARANCE written on it - this one has a wider gap where the press fit section is.
Drainage holes at the bottom to prevent flooding on the inside.
Recommended Settings:
Approx print time on Bambu Lab P1S:
Heart: coloured base is 2h46m and for the top plate 1h15m.
Round: coloured base is 2h56 and for the top plate 1h21m.
Both use less than 150g total for the 2 parts so I would go no lower than 10% infill unless you plan to add an extra wall/top shell layers to provide additional strength otherwise it might be very flimsy unless you don't mind that.
Layer Height: 0.2mm
Nozzle: 0.4mm
Wall Generator: Arachne
Infill: 10-15% Gyroid or Cross Hatch
Supports: None
Commercial license available on my Patreon/Cults linked in my profile if you’d like to sell these.
Full Collection on my Patreon:
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (18)