OneBlade Pro QP6520/20 adjustable comb

Replacement part for the adjustable comb found on the older (perhaps first) model of the OneBlade: https://www.philips.nl/c-p/QP6520_20/oneblade-pro

This is a remix of the later model: https://makerworld.com/en/models/683450-philips-oneblade-pro-qp6505-20-adjustable-comb. The main difference is that this version has 1 pin less so it can close.

Best printed face down with a single support beam for the pin. For replacing the broken part, pry the wheel up until it pops (launches) out. When putting it back in, make sure the wheel is at 0.4 and the part is fully in so it matches up.