Lorcana Illumineer's Quest Box

Lorcana Illumineer's Quest: Deep Trouble & Palace Heist Storage Solution

This storage box is designed to organize all the components from the Disney Lorcana Illumineer's Quest sets, including Deep Trouble and Palace Heist. It provides a clean, custom solution for the official decks, oversized cards, and playmats.

Features

• Three Deck Sections: Each of the three main sections can hold approximately 180 unsleeved cards, 90 sleeved cards, or 1 official Lorcana deck box. In total, the box can store up to 540 unsleeved, 270 sleeved cards or three official Lorcana deck boxes.

   

• Oversized Card Slots: The horizontal slots on the sides are perfectly sized to fit both the paper playmat and the oversized villain cards. You can even store both sets of oversized cards in a single box.

   

• Magnet Closure: The lid and base use magnets to ensure the box stays securely closed. Magnets I used: TRMAG 150Pcs Refrigerator Rare Earth Magnets, Small 6x3mm Neodymium Disc Fridge Magnets, Miniature Mini Multi-Use Round for Crafts, DIY, Whiteboard, Kitchen, Office: Amazon.com: Industrial & Scientific

Assembly Instructions

This print is designed for easy assembly with a few simple steps.

Base & Lid

The base requires four 63 x 33 x 3mm magnets, and the lid requires four of the same size. When gluing them in, please be careful to ensure the magnets are facing the correct way. It's an easy mistake to make and nearly impossible to fix after the glue has dried.

Symbol

The symbol for the lid is a snap-fit piece. Simply push it all the way down into the designated hole on the lid. While it should be a tight fit, a small dab of glue is recommended for extra security. 

Desings

I have designs for a generic Lorcana logo, and a theme for Palace Heist. I intend to upload more later themed around Deep Trouble and Disney's Hercules later.

Printing Notes

• Supports: Use supports only for the lid. The hole where the symbol goes won't be perfectly smooth, but this won't be noticeable once the symbol is in place.
• Material: If you're printing in PLA, please be aware that it can warp in high heat. Avoid leaving the finished box in hot environments, like a car on a hot summer day.

I'm a new designer and love making things I can use myself. I'm always open to advice on how to improve my models and print settings, so feel free to share your suggestions!