Universal Helmet Motorization Kit

If you want to make your helmets motorized by only one servo, this can help you out!

I was making an iron man helmet, with two MG90s servos, but I had issues with them. With an upscaled helmet, the faceplate seemed heavy for the servos, so I was thinking to replace them with one much stronger servo. As I searched for a stronger servo I found the Feetech FS5109M, and it's size was different so I had to make a new set of housing and arms to make it work.

So, what you get here is;

• Housing for Feetech FS5109M servo (I think FS5106M is the same size)
• Arm for the servo to open any faceplates (You will get the small arm with the FS5109M that fits in the servo and the arm itself)
• Arm's guide for the faceplate

Important that this is not a plug and play kit, you have to figure out how to make this work in your helmet.

You also need: 

• 4 bearings and 2 control arms from the crashworks3d Motorization Kit.
• Check out what you need if you want to code your helmet with arduino nano HERE.
• 1 small screw and 1 small metal washer for the end of the control arm so the control arm can't fall out from the control arm's guide.

Feel free to ask, if you not sure of something.