Kitchen Sink Water Splash Guard / Shelf, Pedestal
Print Profile(1)
Description
I was always annoyed that water would get behind the kitchen sink, specifically between the wall and the edge of the sink, where there's usually a gap of about 2-6 cm, varying for everyone.
That's why I created a precisely fitting pedestal and splash guard where you can also place items, and at the same time, it has a slope so that water can flow back into the basin
I naturally made this for my Blanco sink and my specific clearances, but perhaps there are others out there for whom this will also fit
(A smaller version, at least in width, is shown in the picture)
Intended for printing on A1 mini, maximum dimension
Dimensions:
L: 81mm
W: 180mm
H: 30mm
D: 8mm
Sink edge distance: 38mm
Countertop foot: 15mm
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (2)