Hello Kitty makeup brush holder

251122 Update (New print profile added, verified by actual printing)

1. Added limits for the hair clip and adjusted infill to default grid to significantly reduce printing time (however, actual testing under strong light shows that internal grid shadows can be seen on the surface - Figure 2 below: left spiral, right grid; those who mind can change to spiral infill)

2. Optimized the positioning pin of the nose, allowing it to be printed flat (an alternative for unsuccessful angled printing). However, angled printing is recommended as the first choice, as layer lines are less noticeable with the same parameters

3. Help wanted: Regarding the print failure issues reported in the comments section, I performed 3 print tests on these parts and also tested two different materials, but no problems occurred in any of them, so I cannot determine the cause of the problem and correct it; if any expert finds the root cause, please enlighten me, thanks!

---

Hellokitty Pen Holder/Makeup Brush Holder

Making models for my son every day, today I designed one for my wife (I remember this IP has been around for many years, don't know why she suddenly likes this, probably how she feels about my Pokémon too)

Model dimensions approximately 180*145*130mm

Pen holder size diameter 85cm, effective depth 10cm

Fluffy surface, facial features and hair clip are printed separately (assembly requires super glue)

The hair clip has no positioning, you can paste it where you like

PS: The negative parts in the file must not be deleted, if deleted, it will become solid