NagyBig

cover

2024-02-23_did4q0rtzh40.jpg

2024-02-23_o5watnestkjv.png

plate_1.png

Noerbot

IMG_5548.jpg

IMG_5549.jpeg

IMG_5550.jpeg

IMG_5551.jpeg

IMG_5552.jpeg

IMG_5553.jpeg

This is a simple print profile for the provided .stl files. I successfully printed it on my Bambu P1P (see photos), though the tip of the horn is a little jagged. So you might want to experiment with other horn orientations (like the one recommended in the original model).&nbsp;Horn prints separately, but snaps into place on the head (and could be glued for permanent fixture). &nbsp;Supports are a little difficult to get off, but leave a pretty clean surface after using the scraper.&nbsp;Some details:<ul><li>0.16mm layer</li><li>2 walls</li><li>15% infill (gyroid) </li><li>one color</li><li>tree supports included (and required)</li><li>tested with PLA Basic (white)</li><li>top surface pattern: concentric</li></ul>Happy printing, fellow RimWorld nerds!

0.16mm layer, 2 walls, 15% infill, one color, supports, PLA

&nbsp;The body only needs support on the bottom between the legs and under the chin. My slicer tries to support the back of the head and where the fur starts but it's not needed. I removed the supports from there and printed fine.The horn is separate for easier printing. The best way i found to print is in this orientation, seen on the 3rd picture. But if you find a better way go with that. You have to glue the horn in place.&nbsp;Cheers!

Thrumbo - RimWorld

ASIA

Print Profile(1)

Description

Comment & Rating (8)

License

Related Models