Search models, users, collections, and posts
Hyte Y70 Raiser Legs 50mm, Replaces the original.
IP Report
Print Profile(1)
0.2mm layer, 4 walls, 15% infill
Designer
9.9 h
1 plate
Open in Bambu Studio
Boost
21
74
15
5
96
52
Released
Description
Raised legs (50 mm) for the Hyte Y70 — smoother airflow and easier positive-pressure setup. Dropped my 5090 FE gaming temps by about 2°C.
Works best if you configure your fans like this:
- Intake: Bottom + Side (with AIO Radiator)
- Exhaust: Top + Back
Play with the fan curve to guarantee a slight positive pressure.
They replace the stock legs: peel off the rubber pads to pop the originals off, screw the new ones in, and stick the pads back on. Use a pick or a small knife to lift off the support material and reveal the two screw holes on each side. Takes about 10 minutes, tops.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (15)