p1s poop pipe - Free 3D Print Model

Search models, users, collections, and posts

Matthijs

3D Printer>3D Printer Accessories

IP Report

GIF

Print Profile(1)

All

P1S

H2C

H2D Pro

P1P

X1 Carbon

H2S

A1 mini

H2D

P2S

X1E

X2D

A2L

0.2mm layer, 2 walls, 15% infill

Designer

1.8 h

1 plate

4.0(7)

Open in Bambu Studio

Boost

136

321

245

133

Released

Description

a adapter that you can screw to the back of your p1s so you can connect a pipe with a diameter of around 41mm. It is compatible with the spoolholder screws that are included by the p1s.

Comment & Rating (22)

@user_4046979383

Print Profile

0.2mm layer, 2 walls, 15% infill

The curved elbow/tube was modeled wrong/poorly lol just open it up in Bambu lab and look inside. One side wall of the connection between the elbow and cylinder is like paper thin because of the “model’s design” I fixed the design after realizing it was the actual model that was the problem not me… so if you’re going to print this make sure you fix the inside before you ship it off.

(Edited)

Strength Issue:model is paper thin on one side and is poorly modelled.

The profile uploader has replied

@Matthijs_Bos

I’m truly sorry to hear that. It’s quite unusual because I didn’t encounter that issue. I’ll redesign it and publish it, so stay tuned for updates.

@Matthijs_Bos

I’ve made the wals thicker. I hope it’s better now.

@3d_Bums

does this also work for the p2s

The designer has replied

Show original

@Matthijs_Bos

I don’t know because I don’t have one :)

@funkybside

profile slices with a hole where the tube bend starts. (it goes down to a single wall for some reason, then a gap. Any ideas why that happens?

The designer has replied

@Matthijs_Bos

no I have no clue

@Vsig

brilliant idea!!!!!!

The designer has replied

Show original

@Matthijs_Bos

thank you so much!

@Vsig

very good great design looks wonderful works perfectly!!!!

The designer has replied

Show original

@Matthijs_Bos

thanks for the Nice comment!!

@Hoffman0303

Print Profile

0.2mm layer, 2 walls, 15% infill

without supports it turned out messy

The profile uploader has replied

@Matthijs_Bos

I am sorry to hear that. in my first version i had enabled support, but with the updated model, i forgot to enable support. the model is now updated with support enabled

@TBR_Prints

Has this been updated?

The designer has replied

@Matthijs_Bos

yessss

@user_1580961501

The screws do not reach the case. It is better to make the pipe on the outside so that material does not get stuck. In the model, there is a crack on the bend; if material gets in, it will clog the pipe

The designer has replied

Show original