Search models, users, collections, and posts
Snap on festive add on for your bottles
IP Report
Print Profile(1)
0.2mm layer, 3 walls, 15% infill - PLA
Designer
24 min
1 plate
Open in Bambu Studio
Boost
29
52
4
1
31
24
Released
Description
Turn any boring bottle into the life of the party with these snap-on Reindeer Antlers!
Printing Tips:
- Print face down. You’ll only need supports under the arch.
- Enable supports
- The design is sized for a 30 mm bottle cap, but I’ve successfully stretched it onto a 32 mm cap. Your mileage may vary depending on how flexible your filament is.
- For best results, measure your cap and scale the file so the inner diameter ends up about 0.5 mm smaller than the cap.
Make your bottle fabulous. Give it antlers. 🦌🍾
Boost Me (for free)
If you like my design please consider boosting me
License
This user content is licensed under a Standard Digital File License.
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (4)