Search models, users, collections, and posts
4 channel relay enclosure
IP Report
Print Profile(1)
0.2mm layer, 5 walls, 15% infill
Designer
3.9 h
1 plate
Open in Bambu Studio
Boost
9
32
0
0
32
8
Released
Description
I’m building a custom controller for some new landscape lights and I needed an enclosure but I couldn’t find one I liked so I made my own. A little tinkering in Fusion 360, a couple prints, and a few heat-press threaded inserts later, and I have my new box!
I'm using a 4 channel relay board from Amazon with an ESP01 controller running esphome and connected to Home assistant
I also published an example config for esphome and HA. I had a really hard time finding documentation for the board so hopefully this makes it easier.
It uses M4 x 10mm inserts in the exterior corners and M3 x 4mm for the two internal bosses that hold the relay board
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)