Search models, users, collections, and posts
Modular Controller Holder
IP Report
Print Profile(1)
0.24mm layer, 2 walls, 10% infill
Designer
3.2 h
3 plates
Open in Bambu Studio
Boost
214
561
38
12
626
206
Released
Description
A modular controller holder – you can stack them, set them next to eachother, set them back to back, etc.
Uses 6mm diameter, 2mm thickness magnets.
Want to sell prints of my designs? Check out the commercial license on my Patreon!
Boost Me (for free)
If you like this design, please consider giving me a boost! It helps out a lot :)))
Designer's Note: No AI was used at any point in the creation of this file. All design work was done manually, and images have not been enhanced by AI.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (38)