Search models, users, collections, and posts
LifePod 2.0 Insert for Atlas Athena
IP Report
Print Profile(1)
0.2mm layer, 3 walls, 10% infill
Designer
15.7 h
4 plates
Open in Bambu Studio
Boost
42
70
3
2
42
5
Released
Description
This insert accommodates a loaded Atlas Athena with a Trijicon SRO optic and the tactical magwell. The magazine cutouts can fit two, fully loaded 126mm 17-round Atlas magazines, and should also work with Staccato and Check-mate mags. I've also incorporated a desiccant box and tray which slides into the cutout in the insert. The box itself has a handle on the inside for when you need to remove it to recharge/replace your desiccant.
I have included four plates in total:
- Atlas Athena with desiccant
- Atlas Athena with desiccant and Atlas label
- Atlas Athena without desiccant
- Atlas Athena without desiccant or Atlas label
The plates print face down for a nice finish on the exposed side. The only supports required are in the magazine trays, as I had to add a small shelf to allow them to remain at an angle that allowed you to grab them easily. Enjoy!
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (3)