Search models, users, collections, and posts
WALL-E 150W UPS power supply recolored casing
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.4 h
1 plate
Open in Bambu Studio
Boost
0
2
0
0
2
0
Released
Description
Content has been automatically translated.
The WALL-E UPS 150W is currently only available in black. I made a recolored casing for it. The front bezel is 1.5mm thick and fully encloses it, supporting vertical placement. (Customer service says the screen has a planned rotation upgrade function to support vertical placement). It is recommended to tear off and re-paste the bottom foot pads, or you can choose not to tear them off, but the fit will not be as good. It can be printed directly. Since its own heat generation is very low, no heat dissipation is required. A skirt has been added to the bottom of the model; after printing, you can cut it off along the edge with a knife.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (0)