32x64 LED Matrix Enclosure for Pi Zero 2W

A clean, functional enclosure for a 32×64 RGB HUB75 LED matrix powered by a Raspberry Pi Zero 2W. Perfect for ADS-B flight trackers, pixel clocks, stock trackers, weather dashboards, transit boards, or any animated LED display project.
 

This enclosure focuses on printability, airflow, and easy assembly.

Features:

• Designed for a 32x64 LED matrix + Raspberry Pi Zero 2W
• Rear panel includes:
  • 12V DC barrel jack opening
  • Power switch cutout
  • Ventilation slots for airflow and LED heat dissipation
• Front bezel gives the display a clean framed appearance
• Split enclosure design for printers with smaller beds
• Internal hardware provisions allow the two halves to be securely re-joined after printing
• Prints without any supports
• Spacious interior for wiring, power supplies, peripheral electronics RGB matrix bonnet etc.

Assembly Hardware:

To rejoin the two split halves, the enclosure uses:

• 3x M3x14 screws
• 3x M3 nylon locknuts

These drop into the built-in fastening features. Ignore this if you are printing the enclosure in one piece. See attached image showing plane of separation and fasteners.

My Use Case:

Shown running as a live ADS-B flight tracker, with an idle screen displaying time, temperature, and a 3-day weather forecast. Smooth, bright, and extremely readable from across the room.

BOM:

1. HUB75 32x64, 4mm spacing RGB matrix (Tested with Aliexpress and Adafruit displays).
2. Adafruit RGB Matrix Bonnet for Raspberry Pi (Product ID: 3211)
3. SPST power switch (MPN: [will update] )
4. 5.5mm Barrel jack (MPN: [will update] )
5. M3x10 screws for attaching display to enclosure
6. M3x6 screws to attach RPi to the enclosure
7. M3 brass heat-set inserts
8. Display "cover glass" laser cut from 3mm thick LED acrylic (Chemcast Black LED Acrylic Sheet)
    

CODE:
https://github.com/yashmulgaonkar/plane-tracker-rgb-pi


Associated LaserCut Project: https://makerworld.com/en/models/1990941-display-cover-for-32x64-rgb-led-matrix#profileId-2142600