Mirrorless Camera Shock Absorber

The hardware required for the model is as follows:

• 4 shock absorbers with 120mm hole spacing
• 8 bearings (outer diameter 10, inner diameter 4, thickness 4mm)
• 8 M4x50 screws
• 8 M4 nuts
• 4 M3x30 screws (for connecting the ball head holes of the shock absorber)
• 4 M3 nuts
• 4 M6x50 screws
• 4 M6 nuts (or French nuts)
• 【 For connecting Cameras 】 : one G1/4x25mm screw
• 【 Choose One of the two 】 : M6x50 screw + nut , or G1/4x50 screw + nut 
• 【 Optional reinforcing Parts 】 : 8 M3x30 self-tapping screws

The original spring wire diameter of RC car suspension is 1.0mm, which can bear a load of about 1.2kg. It can be matched with 600 grade RC suspension oil. If the load is different, the threaded ring can be rotated according to the needs to adjust the spring pressure. If the load is significantly different from 1.2kg, it is also possible to consider replacing springs with different wire diameters or combining springs with different wire diameters.

Regarding suspension:

It is recommended to purchase shock absorbers with air lungs and adjust them to negative pressure when adding shock absorber oil to ensure stable operation of damping sensation and better shock absorption effect, reducing oil leakage or bubbles in the oil wall

The possibility of occurrence

模型需要的五金件如下：

• 4根120mm孔距的避震
• 8个轴承（外径10，内径4，厚度4mm），
• M4x50螺丝8个，
• M4螺母8个，
• M3x30螺丝4个，（用于连接减震器球头孔）
• M3螺母4个，
• M6x50螺丝4个，
• M6螺母4个（也可是法兰螺母）
• 【用于连接相机】：G1/4x25mm螺丝
• 【2选1】：M6x50螺丝+螺母1个，或G1/4x50螺丝+螺母1个
• 【选择性加强件】：M3x30自攻螺丝8个

RC车避震原装弹簧线径为1.0mm，可承重约1.2kg，可搭配600号RC避震油，若载重不同可根据需求，旋转螺纹圈，调节弹簧压力，若载重与1.2kg差距很大，也可以考虑更换不同线径的弹簧，或组合使用不同线径的弹簧。

关于避震：

建议购买有气肺的避震，并在加注避震油时调节为负压，最大程度保证阻尼感的稳定运行，发挥更好的减震效果，降低漏油或油墙内出现气泡的情况

出现的可能性