Bambu P2S Bed clips

>>> These clips DO NOT FIT to P1S <<<

HERE you will find a "bed" for those clips (which they adore;-)

INTRODUCTION (with a wink ;-)

What is it for?

When printing large objects on the entire or almost entire surface of the plate, the printed model experiences significant material shrinkage, which causes the print to peel off the plate (most often curling up at the corners). To prevent this, brims are used, followed by adhesives. Unfortunately, shrinkage still occurs, but this time the print sticks firmly to the plate and lifts with it. I have personally seen the corners of the plate lifted by as much as 10 mm. That is why clips are needed to hold the plate in place, reducing possible deformation of the print walls or print failure.

Allow me to introduce you to a group of six handsome and extremely helpful plate holders. They have known each other for a long time and have held many things in their lives. They are brave, strong and invincible. It is difficult to find better printing companions today. 

DESCRIPTION

If you are looking for clips for the Bambu P2S plate, you have come to the right place. As it turns out, the clips from the P1S version do not fit its younger sister (brother?), so the god of all creation decided to bring new creatures to the printing table. So... here they are!

There are three types of them, they come in pairs, but they can multiply at will if necessary. Pregnancies (printing time) are short, and births are quick and easy. They are capable of working immediately after birth and can do everything from birth. It's amazing!

You can give them names, but you must always remember their family affiliation, which they bear like a mark on their chest.

• Those with the letter F belong to the FRONT family.
• Those with the letter L belong to the LEFT family.
• Those with the letter R belong to the RIGHT family.

Do not forget this, because they will not be able to work in an environment that is foreign to them! (see the photo below)

PRINTING

Just use PETG or something better, such as ABS, ASA or something with carbon fibre added. Do not use PLA. PLA will produce terrible softies. They may seem hard, but as soon as it gets warmer, they soften like dough.

INSTALLATION

It's a piece of cake! Place the "head" of one of the holders on the plate, then slide its legs under the table. Done! It will take care of the rest.

If you are having problems with the ANY model sticking to the table during printing, check what you can do:

• Make sure the plate is clean, degreased and dry. If necessary, wash it under warm water with soap/dishwashing liquid and dry it thoroughly with a paper towel.
• You can use special plates with increased adhesive properties, such as Bambu Plate SuperTack or CryoGrip, which will not only give you peace of mind about the success of your print, but also allow you to print at much lower bed temperatures.
• Apply a brim around the model (OTHER tab in Bambu Studio).
• Use a special printing adhesive or even just a regular paper glue stick, which also increases adhesion.
• In extreme cases, you can use spray hair gel (e.g. Hegron), but remember that it is difficult to remove from the plate afterwards to clean it - technical acetone and a spatula/scraper are very helpful. 

If you need help with this print or have a fitting issue that cannot be solved simply by scaling the model, let me know in the comments. I will definitely get back to you :-)