Search models, users, collections, and posts
P-Junction - 135°
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 6 walls, 25% infill
Designer
1.7 h
1 plate
Open in Bambu Studio
Boost
9
25
0
0
6
1
Released
Description
Content has been automatically translated.
I designed a remix of the 90° P-junction to create furniture with a 135° angle. I reused the same design, just modifying the angle between the upper battens.
Works very well in PLA depending on your applications. If your prints are exposed to direct sunlight, I recommend PETG.
To be used with 27x27mm battens.
To be printed upright, on the flat face where the vertical support is attached.
This remix is based on
The model does not exist anymoreLicense
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)