Search models, users, collections, and posts
Spoke Hole Plug Hole Diameter 7.8mm
IP Report
Print Profile(2)
(Recommended) V2 Straight Bore 8.5mm
Designer
8 min
1 plate
Anything with a hole diameter greater than 7.8mm can be used. If the hub is wide, you can scale the size appropriately
Designer
8 min
1 plate
Open in Bambu Studio
Boost
0
5
1
0
4
3
Released
Description
Content has been automatically translated.
A plug for the spoke holes in the hub to prevent high-pressure inner tubes from compressing the rim tape, causing it to sink and blow out.
This small part goes under the rim tape.
I was a victim of this myself. Searching online, these things are a bit expensive. I'm sharing this for free. If possible, printing with nylon will make it lighter. Of course, PETG PLA can also be used; I printed mine with PETG.
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (1)