Mideval Knight Pen Holder

11/25/2024 Update:

The hands are small, most pens will just sit on top of the fingers.  

Since there have been a few support issue comments, I have updated the profile to the support settings that seem to work for me and come off very easily except for the ones under the shin-I use a pair of needle nose pliers and gently pry the supports away.  Please check the support settings before you slice, just in case they didn't transfer over correctly, use the settings below.  This should help for the most part.  If you have better support settings, please message me.  Thank you.

Tree supports - I use the default settings for everything except:

0.22 top z distance

0.22 bottom z distance

1.25 base pattern spacing

45 pattern angle

rectilinear interlaced interface pattern

07/31/2024 Update: 

Adjusted the support settings for easier removal.  Most of the supports came off with no issues.  The ones under his shin were a little bit of a pain because of the location.

Stylish pen holder for your desk.

Remixed Knight Pen Holder and added a 3x4 stone floor. Printed this once before with plain base, wanted a different platform.

Enjoy!