Print Profile(1)
Description
NOTE!
This is about installing 230VAC outlets. If you are not an licensed electrician, don't try to connect anything.
Just print and mount the parts and let a licensed electrician do the wiring.
This is some parts that I did to mount some outlets on the base socket in our Willab garden greenhouse.
The outlet is attached to the bracket by M4 screws and nuts, and the bracket is then mounted on the base socket by the same kind of M6 T-slot screws used everywhere in those greenhouses.
There is also some small cable clips that can be twisted in to the T-slot.
The outlet used only have two diagonal mounting holes, and that's probably just fine, however, I put four holes in the bracket and drilled two more holes in the outlet.
If four holes is used the small distans rings shell be used with the two extra holes to support those screws.
- Print the bracket in PETG
- Print the cable clips in TPU
The outlets and cable I used from Clas Ohlson:
Clas Ohlson dual outlet art.nr. 36-9778 https://www.clasohlson.com/se/Cotech-2-vags-utanpaliggande-vagguttag-utomhus-IP44/p/36-9778
Clas Ohlson cable EXQ 3G1,5 art.nr. 36-9732 https://www.clasohlson.com/se/Amokabel-installationskabel-EXQ-3G1,5,-svart/p/36-9732
License
Comment & Rating (0)