「Zenless Zone Zero」3D Printed Huwei Creative Incense Burner & Crossbody Bag Storage Box

N52 magnets, 8mm diameter, 3mm thick, 4 pieces (front face and top attract each other)

N52 magnets, 5mm diameter, 2mm thick, 28 pieces (8 for sides, 6 for back + bottom, 8 for rear flap, 6 for front face)

Screws and nuts m3*14mm, 4 sets (top). m3*10mm, 4 sets (bottom). Self-tapping screws, m3*6mm, 3 pieces (2 for bottom support, 1 for tail).

The added support parts in the slicing are hand-drawn support references (edges with larger horizontal angles do not have chamfers, so supports cannot be automatically generated, which will lead to extremely poor quality). For similar structures, try to add more supports before printing.

Installation suggestions:

If the side is difficult to remove, consider replacing with weaker magnets. Side magnets are difficult to install (it is recommended to heat with a lighter to ensure the magnet can be pressed in and flat, then glue it in place).

After the golden ears are installed (when combining the golden ears, be sure to align the round holes, otherwise the filament won't fit). You can try both the top and bottom to see which embeds better and use that one (the top and bottom models only have slight shape differences, which cannot be distinguished when splitting parts). The side golden spikes are similar.

If you don't plan to install the support frame (the support frame is optional), the cylinders connecting the top and back can be replaced with N52 strong magnets, with the same size as the larger magnets above. (But it is not recommended to hang a rope again).


(If you plan to add lights inside, the yellow of the mouth can be replaced with transparent yellow or transparent red, but re-coloring is required. The same applies to the eyes).