Search models, users, collections, and posts
Hi-Lift handle holder
IP Report
Print Profile(3)
With KM3 tread on top.
Designer
2.2 h
1 plate
Trepador tread on top
Designer
2.1 h
1 plate
0.2mm layer, 3 walls, 16% infill
Designer
2.3 h
1 plate
Open in Bambu Studio
Boost
13
67
4
5
56
34
Released
Description
I've included the screw so it would keep in place. No need to modify anything to be able to use it.
It should fit on most of hi-lifts that mast is 22,5/50mm, and the handle is 33mm in diameter.
The ‘screw’ is reinforced with M3x16mm fallen bolt.
I've printed it in PETG and it does what it is supposed to.
Need to be careful when ‘closing’ it to not shut it too hard - other than that works well.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (4)