Quick winding handle for Gravity-Driven Swiss Lever Escapement

This is an auxiliary winding handle, specifically designed for the Gravity-Driven Swiss Lever Escapement

The original winding handle of his model was very small, and it would be tiring to wind when the string to be coiled was very long,

So I downloaded his STL file, measured the dimensions slightly, and immediately drew this auxiliary handle,

No modifications to the original model are needed; this handle plugs directly on, and two meters of string can be coiled in ten seconds by twisting with both hands.

If it feels a bit slippery, you can wrap some non-slip material around the handle yourself.

Supports need to be enabled during printing. The 3MF I uploaded should already be set up, so you can print directly.

The supports are very easy to remove, they even detach from the model directly when pulled off the plate after printing.

Additionally, I highly recommend his gravity escapement model, which can run for more than ten minutes with just a bottle of water hanging from it; it's a lot of fun.

It's normal for it not to turn at all right after printing; you need to patiently apply a thin layer of grease to each axle and friction surface for it to run smoothly.