Modified Tank into Electronics Housing

Convert the trucks tank into a housing for all the necessary electronics with this print. It's a direct replacement to the original, you don't need to modify anything else. The original tank bands, also hold the receiver in.

It is made for a pair of CR123A batteries in holders, that you can connect in series to get 7.4v, or in parallel and there should be enough room for a voltage convertor in there to suit your motors. I didn't need to fasten the battery holders to the base, as the soldered wires are enough to do that.

I've used a couple of countersunk M2.5 screws to hold the on/off switch for easy access. The end is held in with a M3 screw.