Roof tent heating and vents camper van
Print Profile(2)
Bill of Materials
- Hitze beständiger Schlauch 75mm ca 2,5m lang x 1:
Description
Hello,
Since it can get quite cold in the camper in winter, I designed a small optimization.
We have a roof tent on ours and it's really hard to keep warm.
My solution is to direct the warm air from the vents into the roof tent.
What's included:
2 different adapter plates (the 6-degree angled one is for the connection under the bench seat)
1 roof tent vent with bracket
2 hose connections, 90 degrees and straight
For assembly:
Insert 8 magnets (8x2mm) into each of the required parts (Pay attention to the polarity).
Glue or screw the adapter plate over your vents.
The roof tent vent requires a mounting plate in which it is hung. I attached this with Nanotape to the roof cutout.
Heat-resistant hoses of approx. 70-80mm should fit onto the connections.
Print the parts in PETG at least. I would recommend ASA or ABS as these are more heat resistant.
So if I forgot anything or you have any change requests, just write.
Have fun printing
Update 17.12.2025
By request, the 90-degree connection with an outer diameter of 77 mm has been uploaded as a print profile.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (8)