BuddyBot [Print In Place] Articulated Dummy - Free 3D Print Model

Search models, users, collections, and posts

Waffly3D

Miniatures>People

IP Report

Print Profile(3)

All

A1 mini

P1S

P1P

X1 Carbon

X1E

H2D

H2D Pro

H2S

P2S

H2C

X2D

A2L

Less Tolerance (Bigger Model) 0.28mm layer, 2 walls, 15%

Designer

5 h

1 plate

4.4(48)

0.28mm layer, 2 walls, 15% infill

Designer

4 h

1 plate

2.9(30)

single color 0.28mm layer, 2 walls, 15% infill

2.3 h

1 plate

4.5(2)

Open in Bambu Studio

Boost

740

1541

124

2.9 k

1.2 k

Released

Description

This particular creation was crafted entirely from the ground up utilizing Blender 4.0! The inspiration behind this endeavor stemmed from the Dummy 13 produced by Lucky 13 Toys! This particular endeavor was not about outdoing the Lucky 13, but about simplifying the assembly process (no assembly required other than the hands).

The objective of this design was to incorporate tight printer tolerances so that the model possesses adequate friction to remain upright securely.

All the joints are designed to be closely fit into place when printed. I want to make sure you have a smooth experience.

Feel welcome to create any remixes of this model!

Comment & Rating (124)

@Book_Worm

Print Profile

0.28mm layer, 2 walls, 15% infill

Other Issues:there are strands everywhere all 4 hands had to be thrown away and his whole body is messed up

@JohnnyMa9ic

i had the EXACT same problem :-(

(Edited)

@user_875291174

me too. can't print this. bed is clean. I cleaned it with dish soap and waved it down really well with a paper towel. then I rubbed 99% isopropyl alcohol on the plate. I tried printing this four times and each time I would get spaghetti as it layers up. so frustrating because this could be such a great print.

(Edited)

@user_4119049176

agreed

(Edited)

@Dukester

Initially there was an issue with a profile that the designer corrected quickly. Printed well and looks good , my only suggestion is to include the hands as they are sort of a loose fit

(Edited)

@user_253335270

where did you find assembly instructions?

@user_212719800

it’s print in place

@schrops

Sorry horrible backside …

@user_3168937304

z offset

@user_1885729323

I believe the back can be easily pulled off. I have not printed one yet though.

@Dukester

Print Profile

0.28mm layer, 2 walls, 15% infill

looks good ! great job on the model, keep it up

(Edited)

@mike3D_printer

Boosted

Print Profile

Less Tolerance (Bigger Model) 0.28mm layer, 2 walls, 15%

awesomeness done them for my daughter and her stop motion, posted time lapses on my tiktok tiktok.com/@mikesnotanother3dprinter

@cremer42

Shew… This one tested my patience. My son really wanted this one. After multiple failed prints, I opted for more support. In the end it came out, just okay. I hope he likes it. printed with the standard settings on an X1C with PLA Silk.