Finger Treadmill Fidget Toy (Phone Stand)

Model Introduction:

A creative gadget exclusively for office workers & stress-relief enthusiasts! Exercise your fingers, relieve stress, and double as a phone stand—three uses in one. Available in a large regular version and a small cartoon version, 3D Printed with no supports, pure snap-fit assembly (5 core components),no supports/no screws/no glue,beginner-friendly, PLA filament cost is only a few dollars.

Core Highlights:

Stress-Relief Feature: The repetitive sliding motion brings a sense of healing, use 1-2 minutes during work breaks to relax and relieve anxiety

Hidden Feature: The base has a reserved groove, allowing stable placement of your phone, instantly transforming into a stand for watching shows or reviewing office documents

User-Friendly Assembly: Only 5 core components (display screen/track/stand/protective cover), no glue or screws needed for assembly, even those who are clumsy can complete assembly in 30 seconds

Filament Saving: The cartoon version of a single model uses approximately 200g of PLA material, no support structure needed, the track is ready to use instantly, and installation is simple

Fun Accessories: Add fun accessories like a cup, emergency stop button, finger shoes, etc., for office stress relief and parent-child entertainment

Installation Instructions:

Notes:

Rub the track with your hands multiple times before installation, this will increase its smoothness (as shown in the figure)

If you have WD40 lubricant at home, you can spray a little on the gears, rub it lightly, then let it sit for a day, the lubricant will air dry naturally. After this treatment, the track will be incredibly smooth (as shown in the figure)

When printing the track, there is no need to enable the wipe tower, to avoid wasting material.

Finally:

I'm a newbie in 3D printing, if you have any questions, please leave a comment, and I will resolve them as soon as possible

Please be understanding, thank you for your support