Thicketswept Sleeve for Hand Soap Dispensers

Add a touch of natural elegance to your sink with the Thicketswept soap sleeve, where flowing lines mimic the gentle sway of leaves in the wind. Its high-contrast pattern brings organic movement to your countertop while remaining fully support-free for easy 3D printing. A graceful blend of form and function, perfect for earthy interiors and modern minimalists alike.

This is a decorative sleeve for hand soap dispensers. It was specifically designed for the foaming hand soaps sold by Bath & Body Works. 

It uses two colors, and has zero color changes (the inner sleeve and the outer sleeve are printed separately). 

*********

UPDATE: I uploaded a new print profile with an outer sleeve that only has the Thicketswept pattern on the front (and not the side). It prints laying down, with a bit of support. This profile is for disposable bottles. 

When the outer sleeve prints standing up, some of the contour lines get pretty thin and fragile, especially when printed with “bed slinger” printers. This new print profile addresses the problem by printing it laying down. This makes it much more robust. The outer sleeve is also just a bit thicker. 

This model is open in the back, which is a compromise that allows us to print with limited support. Instead of supporting the whole back, we only need to support the very top (as it lays down on the front). 

*********

Three print profiles are included. Two are for disposable bottles, which are smaller. The other is for refillable bottles, which are larger. 

Choose colors that match the decor in your bathroom or kitchen. 

This model comes with two parts:

• Inner sleeve - A solid color
• Outer sleeve - Thicketswept pattern

Instructions:

• Slide the inner sleeve into the outer sleeve
• Insert your foaming hand soap dispenser into the inner sleeve. 
• Enjoy!

Any rigid filament will work.