Medal Holder Display Case

*PLEASE NOTE THAT THE BACK PLATE DOES NOT COME WITH TEXT ON, YOU NEED TO ADD THAT IN THE SLICER IF YOU WOULD LIKE IT*

This is a clean and modern case to display a medal. It comes with a mount for a wall, which you just put a command strip onto the back and hook the display case onto. It holds the rest of the ribbon of the medal neatly inside the back so everything is nice and tidy.

tip: I found that if you put a tiny bit of blue tack on the back of the medal itself, it helps stop the medal repeatedly banging into the holder when you are trying to move it

Approximate Print time:

1hr, 42mins

Weight:

28g

Sizing:

Small: 40-50mm Medals

Large: 50-60mm Medals

As far as the assembly goes, the back panel requires gluing on, but apart from that, that is it.

I recommend using a tooth pick and superglue to glue it on, using the toothpick to spread the glue evenly on the ledge in the back.

(The ledge to put glue on top, and to put the back onto afterwards)