Nerf Target Shootout! (Print-in-place)

A fun knock-down target game that prints in once piece - no screws, no hardware, no assembly. Just take it off the print bed and start playing. Pick your favorite projectile launcher and knock down all your targets before your opponent to win.  

Infinitely expandable target system, complete with reset lever for quick resets. Print and connect as many modules as you want. And the best part? No tricky assembly required! Each module comes off the print bed with no supports, all moving parts ready to play! I might have had smoke coming out of my ears to get it to work, but it was a fun challenge.

Intended for use with indoor launchers such as nerf guns, blow guns, ping pong ball launchers and others you can find on makerworld. 

Instructions for connecting modules

Assembly is quite easy, each module prints ready to use, all you have to do is use the pin that prints with it to connect it to other modules you have printed already. Make sure to line up the tab on the reset bar as shown when connecting.

Securing targets to a surface (optional)

I added tape tabs to the back of each module so you can tape to your surface if you want. Totally optional but helps prevent the target moving around during play.

I hope you enjoy!!