Kings 60L Draw Fridge Edge Extension

Specifically for the Gen1 60L Draw Fridge - Gen2 has higher sides eliminating the issue this seeks to solve

Sick of having stuff fall over the back of your draw fridge? Sick of always losing that temp sensor at the bottom of the fridge in all the ick that builds up over a long trip? Worry no longer with this ridiculously overkill fridge extention!

This solves my main 3 issues with the draw fridge:

1. Gives a spot for the questionably accurate Kings thermometer to sit
2. Gives a barrier for the rear stopping stuff falling back while keeping the sides accessible
3. Makes the flimsy fit dividers somewhere stronger to fit in the back row,

As a bonus extra works as an ice scraper at the top, clears out those icicles in the top before they become too entrenched.

Basically just pop the parts together - take out any supports from in the holes, tweezers or a drill bit with hand twisting may be neccesary to get the troublesome bits out.

Start off with the thermometer, its press fit but will need quite a bit of force, so place the barrier back down and push in with constant pressure.

Pop the tubes in, they're all numbered so just line up the numbers, be gentle but firm with assembly, glue is optional for a more solid fit.

Slide the draw off the rails to fix the optional clamps at the back. Ensure the rear clamps if fitted are on the metal as well as the plastic of the draw. Fit the side clamps and the optional guide pices (L shaped bits are fragile but not needed so don't stress if these have issues)

Aaaand enjoy your cold, not in danger of falling beers!