Labyrinthbox Geocaching Petling

I have specifically designed this labyrinth box a bit higher so that a Petling fits inside. The box can be used as a normal hideout or as a fishing cache. For this purpose, I have left an opening at the top of the box to thread a wire, band, or similar through.

I have equipped the box with a total of 4 magnets (8x3mm) so that it locks properly when it is in the starting position.

I would estimate the difficulty of the labyrinth at 7/10.

If someone wants to be spoiled, here is the }} solution {{ 

• Inner diameter: 35 mm

• Maximum inner height: 145 mm

• Outer diameter: 65 mm

• Total height: 165 mm

Procedure Print Plate 1:

• Slice Print Plate 1
• move the right slider to layer 73 (9.60mm)
• right-click with the mouse and then insert a pause
• Slice the print plate again and then start the print
• when the printer pauses by itself, insert the magnets and resume printing.

Procedure Print Plate 2:

• Slice Print Plate 2
• move the right slider to layer 1291 (156.00mm)
• right-click with the mouse and then insert a pause
• Slice the print plate again and then start the print
• when the printer pauses by itself, insert the magnets and resume printing.

When inserting the magnets, please pay close attention to the correct polarity of the magnets (they must be oriented correctly, otherwise they will repel each other later).

Please note that PLA is not the optimal filament for outdoor prints. I recommend filament such as PETG-GF or even ASA for optimal durability outdoors under weather influences.