Search models, users, collections, and posts
Print Profile(1)
0.08mm layer
Designer
1.4 h
1 plate
Open in Bambu Studio
Boost
11
17
0
0
8
3
Released
Description
Fits on the A1 Mini!
Check out all of my bookmarks here! https://makerworld.com/en/collections/4201110
To clear any stringing (often inevitable on these 0.08 height prints), just quickly go over the model with a lighter or hot air gun.
AMS Swaps included in the profile.
Swap Instructions: (When not using AMS/making changes in the profile)
- Start with Black
- At layer #9 (0.80mm) swap to White
Strongly recommend printing with 0.08 layer height and 100% infill!
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)