AwithZ UKF10 spot welder usb relocate with drawer

Great little spot welder but the USB cable goes right into the workspace. So I made a stand to relocate the cable off to the side. It uses this cable from amazon. https://www.amazon.com/dp/B0F6796XJ2

Instructions:

Print the parts as they are on the build plate. Only the drawer needs supports. 

Slide the female cable end into the stand. It's a snug fit. Depending on your printer's performance some sanding might be necessary. 

Route the cable in a similar way to the picture and glue in the rail for the drawer. 

Optional step: You can remove the rubber feet off the welder and stick them to the base of the stand

Once the glue is dry you can install the stand onto the welder. It's also a snug fit.