NaterLabs

cover

3.png

2.png

1.png

6197566IwpL._AC_SL1500_.jpg

plate_1.png

2025-11-05_1e0fdbfd0e89e8.png

Profile: 0.20mm Strength @BBL A1Quality:<ul><li>Layer height: 0.2mm</li><li>Initial layer height: 0.2mm</li><li>Seam position: Aligned</li><li>Only one wall on top surfaces: Top surfaces</li><li>Only one wall on first layer: Disabled</li></ul>Strength:<ul><li>Wall loops: 6</li><li>Top surface pattern: Monotonic</li><li>Top shell layers: 5</li><li>Top shell thickness: 1mm</li><li>Top paint penetration layers: 5</li><li>Bottom surface pattern: Monotonic</li><li>Bottom shell layers: 3</li><li>Bottom shell thickness: 0mm</li><li>Bottom paint penetration layers: 3</li><li>Internal solid infill pattern: Rectilinear</li><li>Sparse infill density: 25%</li><li>Sparse infill pattern: Grid</li></ul>Support:<ul><li>Enable support: Disabled</li><li>Type: tree(auto)</li><li>Threshold angle: 30°</li><li>On build plate only: Disabled</li><li>Support/raft base: Default</li><li>Support/raft interface: Default</li></ul>Others:<ul><li>Skirt loops: 0</li><li>Skirt height: 1 layer</li><li>Brim type: Auto</li><li>Brim width: 5mm</li><li>Prime tower: Enabled (35mm width, rib wall enabled)</li><li>Flush into objects&#39; infill: Disabled</li><li>Flush into objects&#39; support: Enabled</li><li>Print sequence: By layer</li><li>Spiral vase: Disabled</li><li>Timelapse: Traditional</li><li>Fuzzy Skin: None</li></ul>

0.2mm layer, 6 walls, 25% infill

This is a simple wall mount for the Aqara Zigbee Motion Sensor P1. I was tired of the sticky tape ripping off the paint if I needed to remove them, or finding them on the floor because the adhesion was bad. You simply slide the motion sensor into the mount then mount it to the wall with a single screw. It&#39;s lightweight enough that you shouldn&#39;t need a drywall anchor or anything like that.

Aqara Motion Sensor P1 Wall Mount

ASIA

Print Profile(1)

Description

Comment & Rating (3)

License

Related Models