Magnetic Soft Jaws - Doyle 8" Groove Joint Pliers

NOTICE!!! ***I WILL BE OUT ON VACATION 6/10/26 ~ 6/15/26*** NOTICE!!!

All Compatible Lightbox Frames & Mounts Available Here!
 

🛠️ Recommended Gear

Check out my Amazon Storefront by clicking here!

Bed Adhesion (Fix First Layer Issues)         Magnets (for optional mounts)

Recommended LED Light Strips     Battery Powered LED Light Strips     Double Sided Tape for Lens: Optional

Custom One-Off Designs Available - CLICK HERE

Printing tips are located at the bottom of this listing

___________________________________________________________________________

I often use these pliers for 3d print assembly and needed a non-marring surface.

Nothing too special but they fit tight and do accept a 5x2 mm magnet (I had none on hand for photos). I have found they stay on without the magnets though.

I made these to fit the DOYLE 8 in. High-Performance Groove Joint Pliers SKU # 64465 from Harbor Freight.

The print profile is setup for PETG but you can use whatever filament you prefer.

_________________________________________________________________________________________________

Thanks for downloading from Chopper Originals.

If this print earned a spot on your printer and you’re out of Boosts, consider buying me a coffee ☕ to help support future designs and releases.

___________________________________________________________________________________

Affiliate Disclosure
Some links in this listing are affiliate links. As an Amazon Associate, I earn from qualifying purchases at no extra cost to you.

____________________________________________________________________________________

Having issues getting that first layer to flow and stick good? Follow these steps, it helps! ***If using an enclosed printer, be sure to remove the lid and leave door open to avoid heat creep***

If using multiple brands/types of filament, you will need to save each as a Custom Filament setting. Otherwise the settings will change when your colors switch.