Search models, users, collections, and posts
HollowKnight Silksong Cogfly
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
4.9 h
4 plates
Open in Bambu Studio
Boost
92
187
16
9
197
121
Released
Description
Made in parts to assemble, I used hot glue to join them but any general use glue should be enough.
Recommended Print Configuration
- Material: PLA if is just decorative or Resin
- 0.20 layer heigh should be enough for FDM, 0.05 layer height should be enought for resin printing.
- Needs supports.
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (16)