Mohammed - LED Name Lamp

"MOHAMMED" as a printable LED name lamp

Letters were scaled to 70% on the X and Y axes. Otherwise, the name is too long.

It can easily be scaled back to 100%.

ATTENTION:
The finished name has been included as an STL. All letters are already arranged in sequence. If the print bed is large enough, you can drag 1-3 letters onto a single plate and print them together. Please do not forget to "merge the letters". Be careful that the letters do not slip, otherwise the LED channels will no longer fit, and the geometry of the entire name will be altered.
 

Print settings: 0.2mm layer height with 8% infill is sufficient. 
For the bodies, I would use "seamless" support for the LED channels.

Please do not scale much smaller. Otherwise, the covers might no longer fit.   
ATTENTION: If scaled too small, the letter channels for the LEDs will also become smaller. (Perform a test print beforehand) - And do not forget to scale the covers as well. 

 

I recommend NOT scaling the X and Y axes smaller than 60%.

The covers can also be printed mirrored on the X-axis. This way, the covers will sit flush at the front. The disadvantage, however, is that the covers are no longer as easy to remove. I recommend printing a mirrored cover as a test beforehand.

The letter pairs must be glued together. Please ensure that the LED channels align flush with each other. A special adhesive for PLA/PETG is best suited for this.

For LEDs, I recommend inexpensive 1-5m RGB LED strips for 8-12€ or, even better, COB-LEDs. Higher-quality RBGIC LEDs, depending on skill, also allow for individually controllable letters.
For this name length, it is advisable to use 5m.

If you have any questions, I am happy to help.


I am happy to create additional custom LED names upon request and a small donation.