Hikvision 4117 Thermal Imaging Phone Back Clip
Print Profile(2)
Description
Suitable for phone widths 7.5cm~9cm, it can be used with the LCSC open-source adapter board, or directly. The small light guide bracket must be printed with transparent filament
Make sure to remove all supports cleanly, otherwise, it will be difficult to install. Buy 0.5*5*20 tension springs online
Apply some rubber sealing grease, which is plastic-specific lubricant, to the slider friction points, otherwise, it won't be smooth. It's sold online, or try applying some wax, not verified if it works
After installing the tension springs on the clamps, swing them up and down to easily insert them into the sliders. If the slider and main body are difficult to install or not in place, check if the print is deformed, a simple repair should suffice
Press the thermal imaging module in at an angle. When removing it, use your thumb to pry the large clamp and pull it out at an angle, finding the right angle will allow for easy removal
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (0)