Search models, users, collections, and posts
Benina Overlocker Thread Holder Cap
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 100% infill
Designer
13 min
1 plate
Open in Bambu Studio
Boost
6
10
3
0
8
6
Released
Description
This is a replacement for the cap that holds the thread guide onto the telescopic pole for a 4 thread overlocker sewing machine.
Over time the cap has managed to break down the centre so rather than glue it together I simply made a simple cap.
Not the best as I'm new to this but it works.
Printed on a P1S using the standard 0.2mm process with a 0.4mm head and using Sunlu white PLA in AMS slot 3.
Set to 100% strength and Rectilinear.
Ironing on topmost surfaces.
Screw the screw into it first to thread the hole, then undo the screw, screw it loosely to the bottom part, slip the metal thread guide in
then tighten the screw.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (3)