Playstation led sign

A table lamp any playstation fan needs .

I have printed it in pla , but i you can i would recomend printing in petg , otherwise don't put the led's on full white power as it might get too hot. 

I used ws2812 led lights , a 5v2a adapter and a sp611e controller with 3pin connector. If you have the time i would recomend using esp32 with wled app.

You can use a single line of led's ,but 2 lines looked better , after soldering the wires to led's push with a  xacto knife or something sharp in the connector . Then you can remove the black plastic and push the wire throught the hole , after that glue in the led's .

With the same xacto knife slightly lift up the small metals on the pins to push the black part back in . 

Add a little bit of glue around the edges and assemble the parts . Everything should fit nicelly .

Thanks for printing , hope you like it .

I have made a bigger 65cm width version that fits on the a1 mini 

https://makerworld.com/en/models/2395984-big-playstation-led-sign-a1mini-compatible-65cm#profileId-2625641