Love in Wine Bookmark

Thank you for downloading my works. If you would like to sell my designs, past and future, a commercial license can be obtained from my MakerWorld or Patreon page.

The Love in Wine bookmark captures the colorization of a fine red wine. The silhouette of a couple made from the displacement of the wine adds to the joyful feeling of sharing a nice bottle with another.

Note: I used ESun engine red(similar to Bambu Maroon Red) for the red and MIKA3D Silk white to get the shimmer for the glass. Any silk white should do the same trick. PLA white was fine, but the silk gave it an edge.

Wine Glass Bookmark

Pictured are printed using an 0.4mm Nozzle

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:

PLA BambuLab Basic Black Transmission Distance: 0.6

PLA Esun Engine Red Transmission Distance: 5 (Or Maroon Red for the wine color look)

PLA BambuLab Basic Jade White Transmission Distance: 4.6

This print uses 3 unique filaments

Swap Instructions:

Start with Black

At layer #8 (0.72mm) swap to Engine Red (Or Maroon Red for the wine color look)

At layer #12 (1.04mm) swap to Jade White for the rest.
 

Can be resized to accommodate your printer or preference by adjusting the X and Y axis the same percentage while leaving the Z axis at 100%. The best way to achieve this: With Uniform Scale checked, adjust the Y axis to the desired size (this will ensure the X axis is the same proportion as the Y axis), uncheck the Uniform scale, adjust the Z axis back to 100%, slice plate, and print. Stringing may occur with Hueforge, just use a lighter to whisk them away. 

More prints: Bookmarks -- Portraits -- Coasters -- Clocks -- Puzzles -- Display Stands -- Display Frames

They are sorted and can be found in my Collections - https://makerworld.com/en/@3djd/collections