Logitech G29/G920/923 mounting plates

My desk didn't allow for clamping my G29 racing wheel due to a drawer under it. This is a simple set of mounting plates to allow for quick and easy clamping and unclamping of Logitech wheel and shifter to a desk where there is no room underneath for the clamps. 

Pros:

This solution makes it so the underside of the peripherals completely clear the desk. 

Makes deployment of said peripherals very quick and repeatable.

Very sturdy and solid. Little chance of breaking or feeling flimsy under normal use.

Cons: 

Requires you to semi permanently screw some hardware to the front of your desk. I personally dont care and it doesn't personally bother me at all when using my desk. In fact, adds an intriguing industrial/gameresque accent to it.

Could offset this by maybe adding threaded inserts to the mounting surface, but would be cumbersome and not necessary imo.

INSTALLATION NOTES:

I screwed these in with wood screws directly into my desk. I will leave the choice of screw type/size to you, depending on your situation.

I recommend to pre-drill your holes. You will need to print 2 x of the wheel plate model, one for each clamp on the wheel to sit on.

I shouldn't need to tell anyone this, but figure out and measure where you want these before butchering your desk.

PRO TIP, I recommend adding some squishy rubber on the surface under where the clamp feet sit. I used an old cut up mouse pad. Not necessary, but will make the connection much tighter. 

You could totally sand these and give them a nice finish as well, since they are just a flat surface on top.

Hope someone finds these useful.