A1 Series Hotend Fidget: Silent Clicker!

          If you wanted an easy to print cool-looking silent clicker, then I've got just the print for you! This hotend clicker based on the quick-swap nozzles used on the A1 Series (and similar to the H2/P2 Series) prints in two parts with a bit of painted support that's quick and easy to remove, and assembly is just two steps! Just press hard on the spring to loosen it, push the heatsink through the pole on the silicone sock, and you've got a pocket sized fidget. I also added a hole through the entire thing, so if for whatever reason you need to thread filament through a dummy nozzle, then this model can also do that. You also don't need to worry about overstretching the spring, because I've integrated a pole through the spring that stops the spring from the inside. 

          I printed these all in PLA and they're holding up great. However, if you want them to have even better results, PETG is recommended. If you're using the multicolor profile, you must use a prime tower, or else the text won't come out solid. You can try, but don't expect the best results. Using a 0.2mm nozzle will yield even better quality results for the text, but I don't know how else the model will perform. Try at your own risk. 

Happy printing! Feel free to leave any suggestions for improvements!