Search models, users, collections, and posts
Skadis Fujifilm XT30II Camera mount
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.5 h
1 plate
Open in Bambu Studio
Boost
8
24
1
0
31
15
Released
Description
Couldn't find a mount for my XT30II on my Skadis board so tried my hand at building one.
Note: this is my first 3d model I made on TinkerCAD so tolerances aren't great and I did have to sand down the holes to fit the hooks just a tad. other than that it fits the camera well and I made it a bit thicker to make sure it didn't break under load. seems very sturdy.
I tried rounding the edges but may have rounded too much since there is some stringyness so feel free to adjust however you'd like.
No Supports needed and printed in PLA
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (1)