FrostEdge – the ice scraper

I could not get over the fact that simple ice scrapers cost money. so i choose to design my own that only costs around 2$ to make.

FrostEdge is a clean, functional, and printable car ice scraper built for cold mornings. Designed to fit anywhere in your car—glovebox, side door, or center console—it’s compact but tough. The built-in hanging hole allows you to store it neatly if you prefer it off the seat.

Two styles are included:

• Standard version: smooth and easy to clean, perfect for everyday use.
• Fuzzy-skin version: textured surface for extra grip, even with gloves on.

You can easily print multiple units and keep one in each spot of your car—driver’s side, trunk, or passenger door—so you’re always ready for frost.

• Material: PETG
• Walls: 3 perimeters
• Infill: 15% gyroid
• Print time: ~1 hour at 100% scale
• Scalable up to 133% for a larger scraper
• No supports required
• Print flat on its back
• Keep good bed adhesion and moderate cooling for best layer strength
• Approx. filament use: ~60 g PETG
• Estimated material cost: ~€1.50 per scraper