Creality K1 Max Tophat Riser

The plexiglass should be 3 mm thick.

Note: Since my top glass broke, I had a plexiglass piece cut to replace it. If you already have a top glass, there’s absolutely no need to cut a plexiglass cover.

I couldn’t find a riser design that fit my preferences, so I created my own. This model is not intended for printing, as the printer interprets it as low quality. That’s why I chose plexiglass  it provides a cleaner look and a more premium feel. It also allows you to view the print from above.

If you plan to cut plexiglass, I recommend using adhesive instead of screws, since screws don’t look very clean.
Apply a small amount of glue to the handle part, push the guides through the holes, and press them in place. Then, trim the excess guides.

You can also glue the side panels from their ends to secure them.

I recommend using at least PETG for printing.