Biyoo
Print Profile(1)
Description
One of the small people that live in my house and annoys me had seen a “Biyoo” (from Omniscient Readers Viewpoint) that sat on your shoulder like a parrot and wanted one for their cosplay.
We came up with this after various iterations.
It uses 2 10mm diameter by 3mm thick magnets in Biyoo’s base and 2 in the “Magnet Plate”. Plate goes inside of a jacket shoulder and snaps to Biyoo’s bum to hold her (it’s a “she” apparently) in place on the outside.
The magnets are a push fit from my printer and didn’t need glue. If they are loose on your print they can be glued in. If they don’t fit, try scaling (for some reason “X-Y hole compensation” isn’t compatible with painted models) the whole model up by a fraction of a percent until they do. If doing this test using the “Magnet Plate” to save wasting filament. They need to be installed so that they snap together as shown in the pictures.
The photo of Biyoo sat on the jacket shoulder is one of the previous iterations without the painted spiral on her horn.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (0)