Halloween Ghost 6 – The Possessed

😱 Halloween Ghost 6 – The Possessed

The Possessed is caught at the peak of its madness… mouth stretched in an unholy scream, hands clawed and twisted by rage. With draped robes pulled tight across its distorted form, this ghost lunges from the wall like something that should have stayed buried. It’s pure chaos, sculpted in stillness.

Perfect as a standalone scare or the wildest piece in your Halloween Ghost wall gallery.

🛠️ Print Info:

• 2 walls
• Top surface: Monotonic line
• Infill: 5% gyroid

Plates

1. 100mm variable layer
2. 100mm 0.16 layer
3. 150mm 0.16 layer
4. 100mm fuzzy skin (0.2 distance, 0.1 thickness)

Key Printing Tips:

• Disable “Strength → Detect Thin Wall” → gives smoother, cleaner surfaces on detailed parts.
• Always check the slicing preview in Bambu Studio before starting the print.
• Support removal trick: Cut supports into small chunks first, then gently loosen → they usually pop off cleanly without damage.
• Some plates use lots of supports, if so → for reliable prints use these filament settings:
  • Filament Overrides
    • Z Hop When Retract: 0.6 mm
    • Z Hop Type: Spiral
    • Travel Distance Threshold: 1 mm
    • ✅ Enable Retract When Changing Layer
  • Also, disable these settings in Bambu Studio if Variable Layer height is used:
    • Supports
      • ❌ Disable Independent Support Layer Height
    • Others
      • ❌ Disable Reduce Infill Retraction
    • I’ve found that a 0.15 mm top Z distance works best when printing with variable layer height.

Happy printing! Can't wait to see photos of your prints! If you're scaling, experimenting or encounter any issues, let me know → your input helps the next iteration. Please share your feedback for any rating below ⭐⭐⭐⭐⭐ so we can work on improving, thank you!